| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Vehicle Interior | Section: Meter/Gauge/Display | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000030W5006X |
| Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Fuel Receiver Gauge Malfunction |
DESCRIPTION
The fuel sender gauge has a variable resistance mechanism. The resistance decreases when the fuel amount increases, and the resistance increases when the fuel amount decreases. The fuel receiver gauge changes based on the resistance of the fuel sender gauge.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK DTC |
(a) Check the DTCs
.
Result
|
Result |
Proceed to |
|---|---|
|
DTC B1500 is not output |
A |
|
DTC B1500 is output |
B |
|
|
2. |
PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream ON.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Combination Meter
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Fuel Meter Operation |
Fuel receiver gauge |
EMPTY, 1/2 or FULL |
- |
OK:
Needle indication is normal.
|
|
|